Nortel Networks manual Network Installation XE Scanner, 5000iNetwork configuration, Computer

Network Installation{ XE "Scanner, 5000i:Network configuration" }

The 5000i scanner in a network configuration requires an NCS Pearson-supplied computer, monitor, keyboard, mouse and required networking equipment. An optional printer may also be installed.

tiger001

Figure 3 – 3: Network Connection

Computer

This section discusses installation and internal cabling for the computer{ XE "Network installation:Computer" } in a network configuration.

Installation

Before installing the computer in the scanner, do the following.

1.Use your fingers (or a screwdriver) to remove the screw (knurled knob) at the rear of the computer (center-top) and lift off the cover. Some models have green plastic covered screws, and some have two screws. Some models have green plastic covered screws, and some have two screws.

CAUTION: Use ESD precautions (including a grounded wrist strap) for steps 2, 3, and 4.

2.Make sure that the scanner interface cards and all ribbon cables are fully seated.

3.Remove the Catgut board from its separate packaging and do the following:

• Ensure that the three 40-pin DIP and one 40-pin SIP headers that connect the Catgut II board to the Catgut I board are fully seated.

Chapter 3. Computer and Peripherals Installation Page 25