Nortel Networks 5000i manual Scanner Installation, Preparation, Hardware, Software

2. Scanner Installation

This chapter describes how to set up and install the standalone 5000i scanner{ XE "Installation:Scanner" },{ XE "Scanner installation:Introduction" } the computer, the monitor, and the mouse.

The 5000i scanner system consists of the following { XE "Scanner installation:Components" }components.

•Model 5000i

•Computer

•SVGA monitor

•Duplex Heads (InfraRed/Red Ink—I/R--heads)

•Transport Printer (optional)

•Bar Code (optional)

Preparation

Before assembling{ XE "Scanner installation:Preparation" } the standalone 5000i scanner, check to make sure that you have all the hardware and accompanying documentation as listed below.

Hardware

•Computer with SVGA monitor, keyboard, mouse, and furniture (standalone only) Documentation: Manufacturer's user manuals

•A model 5000i image scanner with interface card and cable

Documentation: Operator's Guide for the 5000i® Scanner and the Maintenance Manual for the 5000i® Scanner

•Normalization and Calibration forms packet Documentation: Operator's Guide for the 5000i Scanner

Software

•Microsoft® Windows NT® software Documentation: NT User Guide

•Scanner application software

Documentation: Image ScanTools™ User's Guide

•Scanner Exerciser diagnostic software (or equivalent)

Documentation: Operator's Guide for the 5000i and Maintenance Manual for the 5000i® Scanner

Page 6 5000i Scanner Installation Guide