![](/images/new-backgrounds/1205272/205272169x1.webp)
3.Enter Encyption key and select Cipher following instructions on screen. You will need to enter the same key for the first time configuration of each station
4.To save your settings, refer to the section above.
Following is a description of the WEP field settings.
Option | Description |
Enable WEP |
|
Wireless Security | Check this field to enable WEP wireless |
| security. |
Authentication Type | Authentication algorithm to use when |
| the security configuration is set to |
| Legacy. When the security configuration |
| is set to 802.1x or WPA, the authentica- |
| tion algorithm is always open. This field |
| is enabled when the WEP security field |
| is checked. There are three options: |
| • Open: In |
| the access point accepts any station |
| without verifying its identify. |
| • Shared: |
| requires a shared key (WEP encryp- |
| tion key) be distributed to the stations |
| before attempting authentication. |
| • Both: If both is selected, the access |
| point will perform |
| tication, then |
| tion. |
Encryption Key | This field is enabled when the WEP |
| security field is checked. The key’s value |
| that is used when the security configu- |
| ration is set to legacy. The key length |
| must match the WEP cipher. This field is |
| not used when the security configura- |
| tion is set to 802.1x or WPA. |
WEP Cipher | This field is enabled when the WEP |
| security field is checked. You can select |
| from 64 bits, 128 bits, and 256 bits. |
| The WEP cipher that is used when the |
YML754 Rev1 | NB5Plus4/W User Guide |
www.netcomm.com.au | 5 |