Image Quality: Select from Mixed, Photo, HiRes. Mixed, HiRes. Photo.

Density: Sets scan density - -3, -2, -1, 0, +1, +2, +3

Input tray: Select which paper tray you are using, Tray 1, Manual Feeder.

Collate: Select from ON, OFF

N-up:Sets the number of images on a page.

NOTE:

N-up can only be changed from 1in1 if paper size is set to A4 or Letter and documents are scanned from the ADF. Collate always defaults to “OFF”, Reduce/enlarge to “100%”, Edge erase to “0mm (0.001in)” and Margin shift-Right/Bottom to 0 mm (0.00in).

Select from: 1in1, 2in1, 4in1 (horizontal), 4in1 (vertical).

Edge erase: This sets the peripheral areas of the document to block out.

NOTE:

The setting displayed, mm or inch, depends on the setting in Admin Setup - System Setup - Unit of Measure in Menu Mode. If Edge Erase is set to other than "0 mm" or "0.00 in,"

Reduce/Enlarge always defaults to "100%," N-up to "1in1," and Margin Shift-Right/Bottom to "0 mm (0.00 in)".

Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in or

0 mm, 6 mm, 13 mm, 19 mm, 25 mm

Operation > 60