Margin shift - right: This sets the amount to shift the document image to the right.

NOTE:

Any parts of the image that do not fit on the paper as a result of this setting, are not printed. The setting displayed, mm or inch, depends on the setting in Admin Setup - System Setup

-Unit of Measure in Menu Mode. If Margin Shift-Right is set to other than "0 mm" or "0.00 in," Edge Erase always defaults to "0mm (0.00in)" and Reduce/Enlarge can be set only to less than 100%.

Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in or

0 mm, 6 mm, 13 mm, 19 mm, 25 mm

Margin shift - bottom: This sets the amount to shift the document up.

NOTE:

Any parts of the image that do not fit on the paper as a result are printed. The setting displayed, mm or inch, depends on the setting in Admin Setup - System Setup - Unit of Measure in Menu Mode.

If Margin Shift-Right is set to other than "0 mm" or "0.00 in," Edge Erase always defaults to "0mm (0.00in)" and Reduce/ Enlarge can be set only to less than 100%.

Select from: 0.00 in, 0.25 in, 0.50 in, 0.75 in, 1.00 in or

0 mm, 6 mm, 13 mm, 19 mm, 25 mm

4.Press the Left arrow key to return to the start menu.

Operation > 61