Oki ii manual Configuration, Other operating systems, Configuring from network utilities

3.Configure network card.

When printing from Windows 3.1, a NetWare Server is required as Win- dows 3.1 is not a network operating system. Printing via LPR from Win- dows 3.1 connected to the network with other commercial TCP/IP protocols, is not assured.

Other operating systems

Other operating systems, such as Macintosh or UNIX, are not supported.

Configuring from network utilities

The network card configurations may be altered from a PC via the net- work using the utilities on CD-ROM. These can be accessed from the installer. With these utilities, TCP/IP and NetWare parameters may be configured. For details, see the Utilities Manual.

Note:	When using the above utilities, the setup screen for EtherTalk,
	which the fax machine does not support, will be displayed.
	Please set EtherTalk "Disable" to prevent it from being used.

Configuration

Network settings can be altered by selecting 93:NETWORK SETTINGS. To print from Windows using LPR, it is necessary to set the IP ADDRESS. This is not required if printing from NetWare only, but it is necessary for using Internet Fax functions.

•1: IP ADDRESS - Sets the IP address.

•2: SUBNETMASK - Sets the subnet mask.

•3: DEFAULT GATEWAY - Sets the default gateway address. The following three settings are specific to Network Printing.

•80:LAN PRINT T.O. (5 sec., 30 sec., 5min.) - It is impossible to judge whether printing data is not being transmitted due to network delay or the end of the data stream. This time-out configuration allows the device to cancel a print job when no printing data can be found after a specified time has elapsed since the last data was sub- mitted. If the default configuration is acceptable, please do not alter it.

Network Printing 33