TV Installation and Connection Guide

Connecting to a Satellite Receiver or Cable Box with A/V Connectors

Disconnect all power sources before making any connections.

1.Using Audio and S Video cables, connect the satellite receiver's Audio and S Video OUT jacks to the TV Audio and S Video IN jacks.

2.Connect a 75-ohm coaxial cable from your cable or antenna to the TV Ant (Antenna) jack.

Rear of TV

Satellite Receiver or Cable Box

VIDEO-2 VIDEO-1

S VIDEO cable

Yellow

White

A/V cable with RCA connector

Red

ANT

75-ohm coaxial cable

DTV

Audio Output

Note: When you connect video equipment to both the same Video and

S Video input jacks, display will automatically select S Video first.

To view S Video signal, please disconnect Video jack or turn off the

Video signal on the video equipment.

S-Video is strongly recommended for use if your VCR or video equipment has it because S-Video input has better quality of picture than a composite Video signal.

Note: You can also use the Video 2 jacks located on the TV rear, or Video 3 located on the right side of the display to connect additional video equipment.

25

Page 27
Image 27
Olevia LT42HVi manual Rear of TV Satellite Receiver or Cable Box