Adjusting On Screen Displays (OSD) |
Adding Channels Manually
You can add channels manually if they aren't detected by the Auto Scan utility using the following steps:
On the Channel menu page, select "Manual Scan", and then use the
or 
button to select the channel connection: Air, Cable STD,
Cable IRC, or Cable HRC.
Press Enter to highlight the input column, then press numeric buttons to input the channel number. The channel frequency is automatically shown on right side of the input column.
Press the Enter button when the messages "Add channel" and "press Enter to add channel" are shown.
If the ATSC signal is found and locked, you will see the Status message "Get No.XX 8VSB channel success". Press EXIT or Menu to leave the menu and watch the program,
or to scan other channels.
If the signal is not locked, you will see a "no channel" message. You can scan the signal again or refer to the signal level bar "Signal"
for aligning the direction of the antenna to improve the signal.
When the signal is locked and the receiver is on the channel, you can check the signal level.
Note: Contact the antenna installer if you have trouble locking the signal.
Press the EXIT button to return to the main menu or press the MENU button to exit the menu system.
65
