3. Install the digital camera.

Check the digital camera.Check the digital camera before loading it in the Case.Battery Confirmation

The flash is used very frequently during underwater shooting. Make sure that you have enough remaining battery power.

EN Note:

In order to avoid losing shutter chances due to an exhausted battery, you should always replace a battery with a fully charged battery before each dive.

Confirmation of the Remaining Number of Pictures to be Taken

Confirm that the image storage has a sufficient remaining number of pictures to be taken.

Remove the hand strap from the digital camera.When a strap is attached to the digital camera, the hand strap must be removed.

CAUTION:

When a digital camera is loaded without removing the strap, the strap may get caught between the Case lids and may cause water leakage.

When removing the strap, handle the digital camera with sufficient care. OLYMPUS IMAGING CORP. shall not be responsible for damage caused by dropping the camera etc.

Prepare the camera.Applicable Digital Cameras

This product (PT-036) is designed exclusively for use with the µ 760/ Stylus 760 digital camera.

Turn on the digital camera.

To save battery power, the camera automatically goes into sleep mode and the monitor turns off if there is no operation when the camera is turned on. No picture is taken even if the shutter lever is fully pressed in this mode. Operate the zoom buttons or other buttons to restore the camera from sleep mode before taking a picture. If the camera is left for 15 minutes, it automatically turns off. Press POWER button to turn the camera on.

EN 16