2 When the Case is used, left or stored at the following locations,

 

 

defective operation or trouble may occur. This should be

 

 

avoided.

 

 

• Places where the Case can reach high temperature under

 

 

direct sunlight or in a car, places with extremely low

 

 

temperature and places with extreme temperature variations

 

 

• Locations with open fire

 

 

• Locations with volatile substances

 

 

• Locations subject to vibrations

 

 

3 In case of the following handling with a camera loaded into the

EN

 

 

Case, the Case and/or the loaded camera may malfunction or

 

 

may be damaged. This should be avoided.

 

 

• Hitting other objects

 

 

• Dropping

 

 

• Placing heavy objects on top of the Case

 

 

4 When the Case is not used for a long time, trouble may occur

 

 

due to formation of mold. Before use, confirm the operation of

 

 

all operation parts and perform the advance test and the final

 

 

test.

 

Q4:

What cautions must be observed when opening and closing

 

 

the Case?

 

A4:

Pay special attention to the following items.

 

 

1 Do not open and close the Case at locations where there is

 

 

water spray or sand.

 

 

2 Wipe off all waterdrops from the gap between the front lid and

 

 

the rear lid and around projections and recesses such as the

 

 

buckles. Failure to do so may result in waterdrops in the Case

 

 

when opening.

 

 

3 When opening the Case, take care that no water will drip from

 

 

your hair or body into the Case or onto the camera.

 

 

4 When the Case is open, check that no sand, fibers or other

 

 

foreign matter is adhered to the O-ring and the O-ring contact

 

 

surface on the front lid.

 

 

5 Do not touch the camera or the image storage with your hands

 

 

wet with sea water.

 

 

6 If you detect waterdrops or other signs of water leakage while

 

 

shooting, immediately end the dive, perform the water leakage

 

 

test again, and confirm that there is no leakage. If the camera

 

 

is wet, wipe off any moisture and check the operation.

EN 34