Battery level of charge | Omega OSP SERIES instruction

10.11Battery level of charge

•Press the <SEL> key until the following page is displayed :

Set

°C

Lock

e

Set		+ -

°C

Lock

e

Set

°C

Lock

e

The above pages indicate the status of power supply and the level of charge of the battery. When a voltage lower than 4.6V is present a low battery symbol is also displayed.

If the instrument is connected to the main line for battery charge or long term continuous operation a symbol “AC” will be displayed instead of the battery voltage value.

31

Image 31

Omega OSP SERIES manual Battery level of charge

Contents

OSP Series Portable IR thermometers OMEGAnetSM On-Line Service Internet e-mail Info@omega.com Introductory Note Table of Contents Data Acquisition Operative Mode General Description General featuresInnovative design Instrument codes Thermocouple measuring ranges Specifications Target pinpointing General FeaturesGeneral Optical System Self calibration KeyboardDisplay Digital Interface Logging Data Manager Logging ModeCalculated Measurements Case Physical Description Functional Description Power supply Microcontroller Battery chargerFirmware Unpacking ΛEM = 10.6 ∝M PRE-OPERATIONAL Check Power supply from main line AC Power SupplyHow to maximize the life span of the battery Power supply with alkaline batteries Analogue input Laser SightPage Trigger * MEM SEL Enter How to Operate the instrumentOperations Quick Start Laser sighting Hold Working band Weight Unstable temperature measurement Alarm settings HAL Minimum, maximum, average and difference indication Automatic Emissivity Setting Technical Unit selection ConfigurationThermocouple input enabled Temperature Scale selection Acquisition settings Date & Real Time clock setting Actual Target Emissivity Ambient Temp Indicated Temp TAM Ambient Temperature Compensation TAMBuzzer On/Off OSP 500/800 decimal point selection Instrument serial number Firmware revision number Battery level of charge How to operate in data acquisition mode Data Acquisition Operative ModeAcquisition by dedicated Tags Log Recall stored data Logging Data Manager InstallationProgram Architecture Edit FileHelp Data Toolbars Move into an open file Quick startingCopy into an open file Move into a new file Press the or key to select the Tag a identification code Log Page Printer operations Options & AccessoriesSighting telescope system Part n Description Filter installationInstallation of the sighting device Red Point pinpointing systemPage Emissivity Application NotesInfrared energy Applications Digital Interface Digital output wiring practiceTTL to RS 232 adapter Computer data request from OSP to PC Communication protocolComputer Reading values $00 Pyrometer measure Writing values Computer data setting from PC to OSP Example a Communication programsExample a Data transfer from OSP to PC Example B PC instructions to OSP 9Ø Chksum = DATA1 + DATA2 + DATA3 + DATA4 and &H7F Example B Err MaintenanceFaulty operating conditions Storage Appendix A1.1 Typical Emissivity Values A1 How to determine an object emissivity 14 µm A1.2 Metals Typical Emissivity Values A1.3 Non-metals Typical Emissivity Values Index Weight Working band WARRANTY/DISCLAIMER Temperature