Omega Engineering 30 MethodsPrograms00 Information Configuration, to select, Stage, Cycle, Step

In the prompt line is equivalent to the “End” key.

On a program line means the program is locked; it can be copied and then edited but not edited directly.

Up arrow

Down arrow

Enter

Pause

The following terms are used when programming the CYCLER TCY:

Stage	A ‘Stage’ is the name given to the main repeated part of a program
	containing the ‘Steps’ to be repeated. A program can contain a maximum
	of 25 stages although typically only one or two are used.
Cycle	A ‘Cycle’ is the number of repetitions of a ‘Stage’
Step	A ‘Step’ is a user defined program line containing a temperature, a hold
	time and ramp rate. Typically three steps are created within one ‘Stage’.

MethodsPrograms[0][0] Information Configuration

[ , to select ]

** NewprogramMethods****[][]

2 STEP TEMPLATE 501

3 STEP TEMPLATE 502

[ , to select ]

To enter the programming section of the Cycler TCY software, highlight ‘methods’ using the “Up Arrow” or “Down Arrow” keys

Press “Enter”

This screen lists all the programs saved on the unit. Use the “Up Arrow” and “Down

Arrow” keys to scroll through the list.

The number next to the program name is the unique “Speed dial” number allocated to the program for rapid retrieval (see below).

14