1234
SettingsProgram defaults PasswordsSettings FormatPasswordsmemory
Access to the ‘Configuration’ set up is password protected.
Default admin passwords is 1234
To enter configuration, use the alpha keys to type in ‘1234’
Press “Enter”
There are a number of options which can be changed; these are listed here.
Use the “Up Arrow” and “Down Arrow” keys to select then press “Enter” to access any of the options. Each option is discussed in detail below.
Settings
ProgramSettingsdefaults | Highlight ‘Settings’ then press “Enter” |
|
SettingsPasswords
PasswordsFormat memory
SettingsProgram defaults Passwords FormatPasswordsmemory Controller reset
Highlight ‘Settings’ then press “Enter”
Set |
| xx/xx/xx |
Set date | ||
Set time | xx:xx | |
AutoDate restartformat | donmy | |
BeeperAuto restart | on | |
Beeper | on | |
Coms address | 1 | |
Coms | address | 1 |
Coms speed | 19200 | |
Coms | speed | 4800 |
[ | , to select ] | |
The complete list of settings is given here.
Auto restart “on” will allow the unit to restart from where it left off should there be a power failure and the power returns.
The “Comms address” refers to the location of a unit in a daisy chain and must be unique if there are several units linked to each other.
The optimum “Coms speed” is set at 19200. When using a control software, ensure all cyclers are set to the same value.
Edit any line as described for ‘Program
defaults’ above. Press “Enter” | to |
accept the new value. |
|
30
