Cycle 4/30 |
|
| 56m08 | |
Sample | 58.0ºC | 5.7 /S | ||
Hold @ | 58.0ºC | 00m17 | ||
[ | to STOP |
| ] | |
[ | to | PAUSE | ] | |
[ | for | info |
| ] |
During the run the LCD screen will report:
1.The cycle number
2.The time remaining (counting down in seconds)
3.The sample temperature (whether holding or ramping)
4.Maximal ramp rate
5.The current step of the run
6.A count down of the hold time.
An example is shown here.
Manual pause
Cycle 24/30 | 19m26 | |||
Sample | 72.0ºC | 2.7 /S | ||
Hold | @ | 72.0ºC | 00m10 | |
[ |
| PAUSE ? | NO | ] |
[ | YES or | ] | ||
Cycle 24/30 | 19m26 | |
Sample 72.0ºC | 5.7 /S | |
Paused | to STOP | ] |
[ | ||
[ | to CONTINUE ] | |
[ | for info | ] |
To pause a program while it is running, press “Pause”
The run will continue but the prompt line will alternate ‘PAUSE?’ and ‘YES or NO’
To confirm that you want the program to pause press “Enter”
If you have pressed the “Pause” key by mistake and you want the program to continue, press “End”
The unit will emit a beeping sound while paused.
To resume the run, press “Pause ”
followed by “Enter” 
to continue.
Manual Stop
Cycle 28/30 | 10m39 | |||
Sample 94.0ºC | 5.7 /S | |||
Hold | @ 94.0ºC | 00m10 | ||
[ | STOP | PROGRAM? | ] | |
[ | YES | or | NO | ] |
To stop a program while it is running, press “End” 
The run will continue but the prompt line will alternate ‘STOP PROGRAM?’ and ‘YES or NO’
To confirm that you want to stop the program press “Enter”
If you have pressed the “End” 
key by mistake and you want the program to continue, press “End” 
again.
When a program is stopped the unit will emit a beeping sound and the original program screen will appear.
28
