Card Configuration
Several jumpers and one switch must be set on the DBK7 card to match both the system setup and the
signal-conditioning requirements. This section describes a typical configuration. The following table
indicates the factory default settings of each jumper. The below figure shows the location of the jumpers
and DIP-switch (S1).
Factory Defaults for DBK7 On-board Jumpers
Configuration Jumpers Applies to …
Channel Selection, pg. 4
•
•
•
The default is channel 0
Up to 4 cards can share the same J1
channel.
See switch S1 information in regard to
card selection.
J1 16 Channels
JP3 and JP4 CH 0
JP23 and JP24 CH 1
JP43 and JP44 CH 2
Input Circuit Selection, pg. 6
• The default is Analog Input
• Each jumper connects pins 1 and 2
JP63 and JP64 CH 3
JP1 CH 0
JP21 CH 1
JP41 CH 2
Attenuation Selection, pg. 6
• The default is Attenuation Enabled
(reduced sensitivity)
• Each jumper connects pins 1 and 2 JP61 CH 3
JP2 CH 0
JP22 CH 1
JP42 CH 2
Low Pass Filter Selection, pg. 7
• The default is 100 kHz
• Each jumper connects pins 1 and 2
JP62 CH 3
DBK7 Board Layout
DBK Option Cards and Modules 988893 DBK7, pg. 3