Preparing the Remote Controller
Inserting the batteries
1 | 2 | 3 |
1Detach the battery cover.
2Insert two
Be sure to match the + and – ends of the batteries with to diagram inside the battery com- partment.
3Attach the battery cover.
•Do not mix new batteries with old batteries or different kinds of batteries.
•To avoid corrosion, remove the batteries if you do not intend to use the remote controller for a long time.
•Remove dead batteries immediately to avoid damage from corrosion. If the remote control- ler does not operate smoothly, replace both batteries at the same time.
•The life of the supplied batteries is about six months, but this varies with usage.
Using the remote controller
Remote control sensor
Point the remote controller toward the remote control sensor.
•Place the unit away from strong light, such as direct sunlight or inverted fluorescent light, which can prevent proper operation of the remote controller.
•Using another remote controller of the same type in the same room or using the unit near equipment that uses infrared rays may cause operational interference.
•Do not put any object (such as a book) on the remote controller. The buttons of the remote controller may be pressed by mistake, which drains the batteries.
•Make sure the audio rack doors do not have colored glass. Placing the unit behind such doors may prevent proper remote controller operation.
•If there is an obstacle between the remote controller and the remote control sensor, the remote controller will not operate.
18