Connections

Connecting the DVD AV controller (PDR-155) to other components

■Connecting an MD recorder or tape deck (MD/TAPE IN/OUT jacks)

You can connect these jacks to the audio input/output of an MD recorder or tape deck.

If you have connected an Onkyo component that has an jack, set the input indication (INPUT) correctly.

Connecting an Onkyo Separate Collection Series MD recorder or tape deck:

Connect the PDR-155’s MD/TAPE AUDIO IN jacks, and the MD-101A’s ANALOG OUTPUT or K- 501A’s OUTPUT jacks.

Connect the PDR-155’s MD/TAPE AUDIO OUT jacks, and MD-101A’s ANALOG INPUT or K- 501A’s INPUT jacks.

Do not place the MD recorder on top of the PDR-155.

Note that the available components may vary depending on the area.

Connecting other MD recorder or tape deck models

Connect the analog audio output jacks of an MD recorder or tape deck to the PDR-155’s MD/ TAPE AUDIO IN jacks.

Connect the analog audio input jacks of an MD recorder or tape deck to the PDR-155’s MD/TAPE AUDIO OUT jacks.

Digital recording from the PDR-155 to an MD recorder

Use an optical digital cable to connect the PDR-155’s DIGITAL OUT jack to a digital audio input jack on the MD recorder. If you are using the MD-101A, use its DIGITAL INPUT 1 jack.

• Be sure to insert the cable plugs completely into the jacks. If the connection is incomplete, noise or malfunction may occur.

• Do not bundle the audio pin cables with the power cable and/or speaker cords. Otherwise, tonal quality may deteriorate.

• When you use an optical audio digital cable, do not bend or coil it tightly. Otherwise, noise or malfunction may occur.

•After all connections are completed, insert the power cable plug into the appropriate AC outlet (page 40).

•The DIGITAL jack has a protective cap installed. When you use this jack, remove the cap. When you are not using this jack, be sure to replace the cap.

32