Using the Timer Functions

5 Specifying the On time

Press / to specify the timer On time.

When the unit displays the desired time, press

ENTER.

You can also use the number buttons to specify the time. For example, to program 7:29, press RECEIVER, then press 0, 7, 2, and 9.

Press +10 to switch AM and PM on the 12-hour display.

Notes

•When you set the On time, the Off time is automatically set to an hour later.

•If an MD recorder is programmed to start recording by a timer, the first few seconds of the signal may not be recorded. Program the On time to a value that is about one minute earlier than the desired On time.

6

Setting the Off time

Press

/ to set the timer Off time.

 

 

When the unit displays the desired time, press

ENTER.

7 Placing the unit in Standby mode.

STANDBY

Turn off the power to place the unit in Standby mode.

Press STANDBY to place the unit in Standby mode.

•During timer recording, the unit is muted and the subwoofer (SWA-155X) is not turned on. If you wish to audition the sound during recording, press MUTING to cancel mute mode. The subwoofer is turned on and you will be able to hear the sound.

Notes

•If you wish to record FM or AM analog signals to an MD recorder, be sure to select “Analog In” for the MD’s recording input source.

•Unless the unit is in Standby mode, the timer will not work at the programmed time. Be sure to place the unit in Standby mode by pressing STANDBY so that the timer will work.

■Cancelling the timer programming operation

Press TIMER.

93