Listening to the Radio
AM Frequency Step Setup (on some models)
1
2,
1, 5
For AM tuning to work properly, you must specify the AM frequency step used in your area. Note that when this setting is changed, all radio presets are deleted.
To change the frequency step on the TX-SR576,
see page 74.
To change the frequency step on the TX-SR506,
follow the procedure below.
1 | Press the [RECEIVER] button, |
| |
| followed by the [SETUP] button. |
2 | Use the Up and Down [ ]/[ ] |
| buttons to select “0.Hardware- |
Setup,” and then press [ENTER].
3 | Use the Up and Down [ ]/[ ] | |
| buttons to select “AM Freq.” | |
|
|
|
|
|
|
4 Use the Left and Right []/[ ]
buttons to select:
10kHz: Select if 10kHz steps are used in your area.
9kHz: Select if 9kHz steps are used in your area.
5 | Press the [SETUP] button. |
| |
| Setup closes. |
Note:
•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.
49