Zone 2—Continued
Powered Zone 2 Setting3 (TX-SR576 only)
If you’ve connected your Zone 2 speakers to the AV | Use the Up and Down [ ]/[ ] | |
buttons to select | ||
receiver, as explained in “Connecting Your Zone 2 | ||
and then press [ENTER]. | ||
Speakers Directly to the AV receiver” on page 77, you | ||
| ||
must set the Powered Zone 2 setting to Act (Activated). |
|
RECEIVER
ENTER
SETUP
1 | Press the [RECEIVER] REMOTE |
| |
| MODE button, followed by the |
| [SETUP] button. |
2 Use the Up and Down []/[ ] buttons to select “Hardware- Setup,” and then press [ENTER]. If you have a
4 | Use the Up and Down [ ]/[ ] |
| buttons to select “PwrdZ2.”. |
5 | Use the Left and Right [ ]/[ ] |
| buttons to select: |
NotAct: ZONE 2 SPEAKERS L/R speaker terminals not acti- vated (Powered Zone 2 dis- abled).
Act: ZONE 2 SPEAKERS L/R speaker terminals activated (Powered Zone 2 enabled).
6 | Press the [SETUP] button. |
| |
| Setup closes. |
Notes:
•When Act is selected and Zone 2 turned on, the Zone 2 speakers connected to the ZONE 2 L/R speaker termi- nals output sound, but the surround back speakers con- nected to the SURR BACK L/R speaker terminals do not. When Act is selected and Zone 2 turned off, the surround back speakers output sound as normal.
•Powered Zone 2 cannot be used if Sp Type is set to Bi- Amp.
•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.
78