Onkyo TX-SR576 Advanced Setup, Speaker Setup, Buttons to select 2.Speaker, Setup, and then press

Cone diameter

Advanced Setup

Speaker Setup 4

This section explains how to check the speaker settings and how to set them manually, which is useful if you change a speaker after performing the automatic speaker setup.

Some of the speaker settings are set automatically by the Automatic Speaker Setup function (see page 36).

Speaker Configuration

5

These settings are set automatically by the Automatic

Speaker Setup function (see page 36).

This section explains how to specify which speakers are connected and their sizes.

For speakers with a cone diameter

larger than 6-1/2 inches (16 cm), specify Large (full band). For those

with a smaller diameter, specify

Small (default crossover 100Hz). The crossover frequency can be

changed on page 68.

6

1	Press the [RECEIVER] button fol-
	lowed by the [SETUP] button.
	If you have a TX-SR506, proceed to
	step 3.

2	(TX-SR576 only)
	Use the Up and Down [ ]/[ ]
	buttons to select “2.Speaker
	Setup,” and then press the
	[ENTER] button.

7

3 Use the Up and Down []/[ ] buttons to select “Sp Config,” and then press the [ENTER] but- ton.

While the “Subwoofer” setting is selected, use the Left and Right []/[ ] buttons to select Yes or No.

Yes: Select if a subwoofer is con- nected.

No: Select if no subwoofer is con- nected.

Use the Down [ ] button to select “Front,” and then use the Left and Right []/[ ] buttons to select Small or Large.

Small: Select if the front speakers are small.

Large: Select if the front speakers are large.

Note:

•If the Subwoofer setting in step 4 is set to No, this setting is fixed at Large and does not appear.

Use the Down [ ] button to select “Center (Cntr),” and then use the Left and Right []/[ ] buttons to select Small, Large, or None.

Small: Select if the center speaker is small.

Large: Select if the center speaker is large.

None: Select if no center speaker is connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

Use the Down [ ] button to select “Surround (Surr),” and then use the Left and Right

[]/[ ] buttons to select Small, Large, or None.

Small: Select if the surround speak- ers are small.

Large: Select if the surround speak- ers are large.

None: Select if no surround speakers are connected.

Note:

•If the Front setting in step 5 is set to Small, the Large option cannot be selected.

67