First Time
To Retry the Automatic Speaker Setup
Press the [ENTER] button.
Make sure speakers that cannot be detected are connected properly.
Changing the Speaker Settings Manually
If you wish to make changes to the settings found during the automatic speaker setup, follow the directions on pages
Using a Powered Subwoofer
If you’re using a powered subwoofer, as it outputs very
Speaker Settings
If you change these settings, you must run the auto- matic speaker setup again (see page 36).
RECEIVER
ENTER
SETUP
If the impedance of any speaker is 4 ohms or more but less than 6, set the Speaker Impedance to 4 ohms.
North American models do not support speakers with an impedance of less than 6 ohms.
To use
Notes:
•When
•Before you change these settings, turn down the vol- ume.
For
1 | Press the [RECEIVER] button, |
| |
| followed by the [SETUP] button. |
2 | Use the Up and Down [ ]/[ ] |
| buttons to select “0.Hardware- |
Setup,” and then press [ENTER].
3 | Use use the Left and Right |
| |
| [ ]/[ ] buttons to select the |
| speaker impedance: |
4 ohms: Select if the impedance of any speaker is 4 ohms or more but less than 6.
6 ohms: Select if the impedances of all speakers are between 6 and 16 ohms.
4 | Use the Up and Down [ | ]/[ | ] |
| buttons to select “Sp Type,” and | ||
| use the Left and Right [ | ]/[ | ] |
| buttons to select: |
|
|
Normal: Select this if you’ve con- nected your front speakers normally.
5 | Press the [SETUP] button. |
| |
| Setup closes. |
Note:
•This procedure can also be performed on the AV receiver by using its [SETUP], [ENTER], and arrow buttons.
38