Prestige 201 ISDN Access Router
Menu 2.2 - NetCAPI Setup
Active= Yes
Max Number of Registered Users= 1
Incoming Data Call Number Matching= NetCAPI
Access List: |
|
|
Start IP | End IP | Operation |
192.168.1.132 | 192.168.1.145 | Both |
192.168.14.1 | 192.168.14.32 | Imcoming |
192.168.20.7 | 192.168.20.12 | Outgoing |
192.168.30.1 | 192.168.30.3 | Both |
10.0.0.0 | 10.255.255.255 | Incoming |
_______________ | _____________ | _______ |
_______________ | _____________ | _______ |
_______________ | _____________ | _______ |
default |
| Both |
Press ENTER to Confirm or ESC to Cancel:
Figure 2-14 Menu 2.2 - NetCAPI Setup
Set the fields in the above menu according to the following description.
| Table |
Field | Description |
Active | This field allows you to enable or disable NetCAPI. Press the [Spacebar] to toggle |
| between Yes and No |
Max Number of | When you want to use NetCAPI to place outgoing calls or to listen to incoming calls, |
Registered Users | you must start RVSCOM on your workstation, and RVSCOM will register itself to the |
| Prestige. This option is the maximum number of clients that the Prestige supports at the |
| same time. The default value is 4. |
Incoming Data | This field will be removed in future release. Now it has fixed value of NetCAPI. |
Call Number |
|
Matching |
|
Access List | This list specifies users that can use NetCAPI. This access list controls if a client is |
| allowed to use NetCAPI. The request is rejected when |
| 1. The IP address of the workstation is not between Start IP and End IP or |
| 2. The request from the workstation is not permitted as specified in the |
Hardware Installation & Initial Setup |
