
Prestige 201 ISDN Access Router
series of standard commands to the terminal. The CAPI standard defines the commands and allows you to use a
CAPI also simplifies the development of ISDN applications through many default values that do not need to be programmed. It provides a unified interface for applications to access the different ISDN services such as data, voice, fax, telephony, etc.
ISDN-DCP
Using
2.10.4 RVS-COM
NetCAPI can carry out CAPI applications only if the CAPI driver is installed on your workstation. In addition to the CAPI driver, you will need a communication software program such as
The ISDN router is a shared device and can be used by several different client workstations at the same time: e.g. one workstation sending a fax, another workstation doing a file transfer.
Configuring the P201 as a NetCAPI Server
This section describes how to configure your Prestige to be a NetCAPI server using the SMT (System Management Terminal).
[Note : For configuring your Prestige with the PNC, use PNC version 2.10 and above.]
By default, NetCAPI is enabled on your Prestige. When NetCAPI is enabled, the Prestige listens for incoming DCP messages from the workstations. By default, the Prestige listens for DCP messages on TCP port 2578.
Hardware Installation & Initial Setup |