ZyXEL Communications P-202 manual TCP/IP Filter Rule Menu Fields, Field Description Option

Prestige 201 ISDN Access Router

Menu 21.1.1 - TCP/IP Filter Rule

Filter #: 1,1

Filter Type= TCP/IP Filter Rule

Active= Yes

IP Protocol= 6	IP Source Route= No
Destination: IP Addr= 0.0.0.0
IP Mask= 0.0.0.0
Port #= 137
Port #	Comp= Equal

Source: IP Addr= 0.0.0.0

IP Mask= 0.0.0.0

Port #= 0

	Port #	Comp= None
TCP Estab= No
More= No		Log= None
Action	Matched= Check Next Rule
Action	Not Matched= Check Next Rule

Press ENTER to Confirm or ESC to Cancel:

Press Space Bar to Toggle.

Figure 6-7 Menu 21.1.1 - TCP/IP Filter Rule

The following table describes how to configure your TCP/IP filter rule.

Table 6-4 TCP/IP Filter Rule Menu Fields

Field	Description	Option
Active	This field activates/deactivates the filter rule.	Yes/No
IP Protocol	Protocol refers to the upper layer protocol, e.g., TCP is 6,	0-255
	UDP is 17 and ICMP is 1. This value must be between 0
	and 255
IP Source Route	If Yes, the rule applies to packet with IP source route	Yes/No
	option; else the packet must not have source route option.
	The majority of IP packets do not have source route.
Destination: IP	Enter the destination IP Address of the packet you wish to	IP address
Addr	filter. This field is a don’t-care if it is 0.0.0.0.
Destination: IP	Enter the IP subnet mask to apply to the Destination: IP	Subnet mask
Mask	Addr.
Destination: Port #	Enter the destination port of the packets that you wish to	0-65535
	filter. The range of this field is 0 to 65535. This field is a
	don’t-care if it is 0.
Destination: Port #	Select the comparison to apply to the destination port in	None/Less/Greater/
Comp	the packet against the value given in Destination: Port #.	Equal/Not Equal]

Filter Configuration 6-9