Onkyo TX-SR8360, TX-SR603/603E Crossover, Double Bass, Buttons to select a crossover frequency

First Time Setup—Continued

Crossover

9	Use the Up and Down [ ]/[ ]
	buttons to select “g. Crossover,”

and then use the Left and Right

ENTER

[]/[ ] buttons to select a crossover frequency.

Choose a crossover frequency suitable for your setup. If you’re using a sub- woofer, choose a crossover frequency based on the diameter of your front speakers. If you’re not using a sub- woofer, use the diameter of any speaker that you specified as Small.

Speaker cone	Crossover
diameter	frequency
Over 8 in.	60 Hz
(20 cm)
6-1/2 to 8 in.	80 Hz
(16–20 cm)
5-1/4 to 6-1/2 in.	100 Hz
(13–16 cm)
3-1/2 to 5-1/4 in.	120 Hz
(9–13 cm)
Under 3-1/2 in.	150 Hz
(9 cm)

Continue with step 10 in the right col- umn.

Note:

If the crossover frequency is set to a low value, and the program material doesn’t contain any sounds below that frequency, the subwoofer will not output much sound.

Double Bass

This setting is not set automatically by the Automatic Speaker Setup function (see page 39).

With the Double Bass function, you can boost bass out- put by feeding bass sounds from the front left and right channels to the subwoofer. This function can be set only if the Subwoofer setting in step 3 is set to Yes, and the Front setting in step 4 is set to Large.

In the speaker setup screen, you can choose how bass information is distributed to your speakers only if you have large front left and right speakers AND a sub- woofer.

10	Use the Up and Down [ ]/[ ]
	buttons to select “h. Double

Bass,” and then use the Left and

ENTER

Right []/[ ] buttons to select:

On: Double Bass function on (default). Front left and right bass also goes to the sub- woofer simultaneously.

Off: Double Bass function off.

11	Press the [SETUP] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

48