Onkyo TX-SR8360, TX-SR603/603E Connecting Antenna, Connecting the Indoor FM Antenna, Other Models

Connecting the AV Receiver—Continued

Connecting Antenna

This section explains how to connect the supplied indoor FM antenna and AM loop antenna, and how to connect commercially available outdoor FM and AM antennas. The AV receiver won’t pick up any radio signals without any antenna connected, so you must connect the antenna to use the tuner.

AM antenna push terminals

FM antenna connector

IR IN
	12 V TRIGGER OUT
	ZONE 2			TX-SR603E
DIGITAL
COAXIAL							ZONE 2	SURROUND BACK
		ANTENNA					SPEAKERS	SPEAKERS	SURROUND SPEAKERS	FRONT SPEAKERS
	COMPONENT VIDEO		AM	FM 75
	Y
							L			L
						MONITOR
OPTI-	P	VIDEO 3	VIDEO 2	VIDEO 1	DVD	OUT
CAL							L
						V
	P						R
							R			R
						S

ZONE 2	PRE OUT
LINEOUT

L	L	SUB
		WOOFER
R	R

						SUB
CD	TAPE	VIDEO 3	VIDEO 2	VIDEO 1	DVD	WOOFER	CENTER SPEAKER

Connecting the Indoor FM Antenna

The supplied indoor FM antenna is for indoor use only.

1 Attach the FM antenna, as shown.

■North American Model

Insert the plug fully into the jack.

■Other Models

Insert the plug fully into the jack.

Once your AV receiver is ready for use, you’ll need to tune into an FM radio station and adjust the position of the FM antenna to achieve the best possible reception.

2 Use thumbtacks or something similar to fix the FM antenna into position.

Thumbtacks, etc.

If you cannot achieve good reception with the supplied indoor FM antenna, try a commercially available out- door FM antenna instead (see page 25).

Connecting the AM Loop Antenna

The supplied indoor AM loop antenna is for indoor use only.

1 Assemble the AM loop antenna, inserting the tabs into the base, as shown.

2 Connect both wires of the AM loop antenna to the AM push terminals, as shown.

(The antenna’s wires are not polarity sensitive, so they can be connected either way around). Make sure that the wires are attached securely and that the push terminals are gripping the bare wires, not the insulation.

Push Insert wire Release

Once your AV receiver is ready for use, you’ll need to tune into an AM radio station and adjust the position of the AM antenna to achieve the best possible reception.

Keep the antenna as far away as possible from your AV receiver, TV, speaker cables, and power cords.

If you cannot achieve good reception with the supplied indoor AM loop antenna, try using it with a commer- cially available outdoor AM antenna (see page 25).

Caution: Be careful that you don’t injure yourself when using thumbtacks.

24