Onkyo TX-SR8360, TX-SR603/603E Controlling Other Components, Entering Remote Control Codes, page

Controlling Other Components

You can use the AV Receiver’s remote controller (RC-590M/RC-591M) to control your other compo- nents, including those made by other manufacturers. This chapter explains how to:

•Enter the remote control code for a component that you want to control (e.g., DVD, TV, VCR).

•Learn commands directly from another component’s remote controller (see page 86).

•Program the Macro function to perform a sequence of actions with a single press of a button (see page 87).

Entering Remote Control Codes

Entering the appropriate remote control code for each REMOTE MODE button will allow you to control your other components with the remote controller.You’ll need to perform this procedure for each component that you want to control.

For the [DVD], [TV], [VCR], [CABLE], and [SAT] but- tons, choose a code from the respective category. For the [CD] and [MD/CDR] buttons, you can choose a code from any category. Remote control codes cannot be entered for the [RECEIVER] and [ZONE 2] buttons.

2

3

2

1	Look up the remote control code
	for your component.
	See “Remote Control Codes” on
	page 80.

2	While holding down the REMOTE
	MODE button that you want to
	enter the code for, press the
	[STANDBY] button.

STANDBY

3	Within 30 seconds, use the num-
	ber buttons to enter the 4-digit
	remote control code.

4	Select the remote controller
	mode, point the remote control-
	ler at the component, and check
	its operation.
	Remote controller buttons that can be
	used in DVD mode are shown on
	page 16. Those that can be used with
	the TV, VCR, CABLE, and SAT modes
	are shown on pages 84, 85.

If the remote controller works OK, the code has been entered correctly. If not, try again or try another code.

Codes for Onkyo DVD Players

The remote control code for an Onkyo DVD player

depends on whether it’s connected via , as follows:

5001: Use this code if you’ve connected an cable and an analog audio cable to your DVD player. This is the default setting, so if you’re using , you don’t need to change anything. Point the remote controller at the AV receiver to operate the DVD player.

5002: Use this code if your DVD player doesn’t have

an jack, or you’re not using . Point the remote controller at the DVD player to operate it.

Setting the [MD/CDR] Button to CDR

By default, the [MD/CDR] button is set to control a MiniDisc recorder. To control a CD recorder, it must be set to CDR. The codes are as follows:

6002: Code for controlling an CD recorder.

6003: Code for controlling an MD recorder (default).

78