Onkyo TX-SR8360, TX-SR603/603E instruction manual Assigning Listening Modes to Input Sources

Advanced Setup—Continued

Assigning Listening Modes to Input Sources

You can assign a default listening mode to each input source that will be selected automatically when you select each input source. For example, you can set the default listening mode to be used with Dolby Digital input signals. You can select other listening modes dur- ing playback, but the mode specified here will be resumed once the AV receiver has been set to Standby.

1		Press the [RECEIVER] button fol-
	RECEIVER	lowed by the [SETUP] button.

The main menu appears onscreen.

2	Use the Up and Down [ ]/[ ]
	buttons to select “6. Input

ENTER	Setup,” and then press [ENTER].
	The Input Setup menu appears.
ENTER

3	Use the INPUT SELECTOR but-
	tons on the remote controller to
	select the input source that you
	want to set.
	For input selectors that have no digital
	input jacks, only “b. Analog” will be
	available.

4	Use the Up and Down [ ]/[	]
	buttons to select the signal for-
ENTER	mat that you want to set, and
	then use the Left and Right [	]/

[ ] buttons to select a listening mode.

Only listening modes that can be used with each input signal format can be selected.

For “Surround,” the listening mode specified on page 69 will be used. The Last Valid option means that the listening mode selected last will be used.

b. Ana/PCM: With this setting, you can specify the listening mode to be used when an analog (CD, TV, LD, VHS, MD, turntable, radio, cassette, cable, satellite, etc.) or PCM digital (CD, DVD, etc.) audio signal is played. c. Dolby D: With this setting, you can specify the listening mode to be used when a Dolby Digital format digital audio signal is played (DVD, etc.).

d. DTS: With this setting, you can specify the listening mode to be used when a DTS format digital audio signal is played (DVD, LD, CD, etc.).

e. D.F. 2ch: With this setting, you can specify the listening mode to be used when a 2-channel (2/0) digital audio signal (Dolby Digital, DTS) is played (DVD, etc.).

f. Mono: With this setting, you can specify the listening mode to be used when a mono digital audio signal is played (DVD, etc.).

g. Multich: This setting is available only when DVD or MULTI CH is selected with INPUT SELECTOR. With this setting, you can specify the listening mode to be used when the DVD analog multichannel input is used.

5	When you’ve finished, press the
	[SETUP] button.
	The setup menu closes.

Note:

This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

70