Onkyo TX-SR8360 Basic Operations-Continued, Using the Sleep Timer, Setting the Display Brightness

Basic Operations—Continued
		Using the Sleep Timer
		With the sleep timer, you can set the AV receiver to turn
		off automatically after a specified period.
Press			Press the [RECEIVER] button,
			and then press the [SLEEP] but-
[RECEIVER]		RECEIVER
first			ton repeatedly to select the
DIMMER	SLEEP		required sleep time.
			The sleep time can be set from 90 to 10
		SLEEP
			minutes in 10 minute steps.
			The SLEEP indicator appears on the
	MUTING		display when the sleep timer has been
			set. The specified sleep time appears on
			the display for about five seconds, then
			the previous display reappears.
		If you need to cancel the sleep timer, press the [SLEEP]
Setting the Display Brightness		button repeatedly until the SLEEP indicator disappears.
		To check the time remaining until the AV receiver sleeps,
You can adjust the brightness of the display.		press the [SLEEP] button. Note that if you press the
	Press the [RECEIVER] button,	[SLEEP] button while the sleep time is being displayed,
RECEIVER		you’ll shorten the sleep time by 10 minutes.
	and then press the [DIMMER]

DIMMER

button repeatedly to select:

•Normal+VOLUME light on.

•Normal+VOLUME light off.

•Dim+VOLUME light off.

•Dimmer+VOLUME light off.

Using Headphones

You can connect a pair of stereo headphones (1/4-inch phone plug) to the AV receiver’s PHONES jack for pri- vate listening, as shown.

Muting the AV Receiver

You can temporarily mute the output of the AV receiver.

Press the [RECEIVER] button,

RECEIVER and then press the [MUTING] but- ton.

The output is muted and the MUTING indicator flashes on the display, as shown.

MUTING

To unmute the AV receiver, press the [MUTING] button again, or adjust the volume.

The Mute function is cancelled when the AV receiver is set to Standby.

PHONES

Notes:

•Always turn down the volume before connecting your headphones.

•The speakers are turned off while the headphones plug is inserted in the PHONES jack (Zone 2 speakers are not turned off).

•When you connect a pair of headphones, the listening mode is set to Stereo, unless it’s already set to Stereo, Mono, Direct, or Pure Audio (not North American TX-SR603).

•Only the Stereo, Direct, Pure Audio (not North Amer- ican TX-SR603), and Mono listening modes can be used with headphones (the listening modes available also depends on the currently selected input source).

•When the multichannel input is used, only the front left and right audio can be heard in the headphones.

•To adjust the headphone level, press the [CH SEL] button on the remote controller, and then press the [LEVEL +]/[LEVEL -] buttons. You can adjust the level between –12 dB and +12 dB.

54