Orion 2xx manual 5.2Agency Approvals, Entity parameters Fieldbus Fisco

5.2Agency Approvals

AGENCY	MODEL	PROTECTION METHOD	AREA CLASSIFICATION
FM & CSA	2X1-XXXXXXX-XXX	Intrinsically Safe	Class I, Div. 1:
	2X2-XXXXXXX-XXX		Groups A, B, C, & D
	2X3-XXXXXXX-XXX		Class II, Div. 1:
	2X4-XXXXXXX-XXX		Groups E, F, & G
			Class III, IP66 TYPE 4X, T4
			FISCO
	2XX-XXXXXXX-XXX	Explosion Proof ➀	Class I, Div. 1
			Groups B, C, & D
			Class II, Div. 1
			Groups E, F, & G
			Class III, IP66 Type 4X T5 at 80° C
	2XX-XXXXXXX-XXX	Non-Incendive	Class I, Div. 2
			Groups A, B, C, & D
			Class II, Div. 2
			Groups E, F, & G ➁
			Class III, IP66 Type 4X T5 at 80° C
ATEX	2XA-XXXXXXX-XXX	Flame Proof	II 1/2 G EExd IIC T6
	2XB-XXXXXXX-XXX
	2XC-XXXXXXX-XXX
	2XD-XXXXXXX-XXX
	2XE-XXXXXXX-XXX	Intrinsically Safe ➂	II 1 G EEx ia IIC T4
	2XF-XXXXXXX-XXX		FISCO
	2XG-XXXXXXX-XXX
	2XH-XXXXXXX-XXX

➀ M20 conduit connections not CSA approved explosion proof ➁ FM approval Class II, Div. 2 Groups F & G only

➂ Materials marked as category 1 equipment and used in hazardous areas requiring this category, shall be installed in such a way that, even in the event of rare incidents, the aluminum enclosure cannot be an ignition source due to impact or friction

5.2.1Agency Specifications – Explosion Proof Installation

Factory Sealed: This product has been approved by Factory Mutual Research (FM) and Canadian Standards Association (CSA) as a Factory Sealed device.

NOTE: Factory Sealed: No Explosion Proof conduit fitting (EY seal) is required within 18" of the transmitter. However, an Explosion Proof conduit fitting (EY seal) is required between the haz- ardous and safe areas.

Caution: Grounding (+) will cause faulty operation, but will not cause permanent damage.

5.2.2Agency specifications ATEX Intrinsically safe

Entity parameters Fieldbus Fisco:

Ui = 17.5V Ii=380mA Pi = 5.32W Ci = 0.705 nF Li = 3µH

46-649 Jupiter Magnetostrictive Transmitter - FOUNDATION fieldbus™ 22