Ositech comm Trumpcard Data/Fax Modem manual Set Tone Dial as Default, Vn Result Code Form

	Modem Command Reference
Examples
ATSn	Establishes S-register n as the default register
ATSn=x	Set S-register n to the value x
ATSn?	Reports the value of S-register n

T — Set Tone Dial as Default

Parameters: none

Default:none

Causes the modem to assume that all subsequent dial commands are tone dialled. The user may omit the “T” from the dial string.

Vn — Result Code Form

Parameters 0 or 1

Default1

Selects whether the modem returns long form or short form result codes. All responses are ASCII values. Long-form (verbose) responses are preceded and terminated with both carriage return and line feed control characters. Short-form (numeric) responses are only terminated with a carriage return control character (see Xn command).

Examples

ATV0	Allows short-form (numeric) result codes to be sent.
ATV1	Allows long-form (verbose) result codes to be sent.
Wn — Connect Message Control
Parameters	0, 1, or 2
Default	0

This command controls which message(s) are reported upon connection. These messages can also be reported in either numeric or verbose form. For example, both 77 and PROTOCOL:LAP-M indicates that the error- correction protocol is LAP-M. (See Xn command.)

Examples

ATW0	Upon connection report CONNECT XXXX only
ATW1	Upon connection report CARRIER XXXX,
	PROTOCOL XXXX and CONNECT XXXX
ATW2	Upon connection report CONNECT XXXX only

User’s Guide and Reference 4 - 15