105
Hardware Diagnostics
BClick the icon for the hardware that is not to be checked, so th at the icon is displayed in gray (B).
When running a check on the memory or the hard disk, click ing the icon once will turn on the
extended diagnostic check (“FULL” (C) will be disp layed below the icon); click again, and the icon
will be displayed in gray (D).
CClick to start the diagnostic check.
6When all the hardware has been checked, confirm the diagnostic check results.
If the display is red and the message “Check Result TEST FAILED” is displa yed, you can assume that there is a
problem with the computer’s hardware. Confirm which h ardware component is displayed as red, and contact Pana-
sonic Technical Support.
If the display is green and the message “Check Result TEST PASSED” is displayed, the computer’s hardware is
operating normally. Continue using the computer as it is. If the computer still does not operate prop erly, reinstall the
software (⇒OPERATING INSTRUCTIONS “Reinstalling Software”).
NOTE
If you run a memory diagnostic check after installing a new RAM module (sold separately) and the message “Check
Result TEST FAILED” is displayed:
Remove the additional RAM module and run the diagnostic check again. If the message “Check Result TEST FAILED”
is still displayed, you can assume that there is a problem with the internal RAM module.
7After the diagnostic check is complete, click (close), or press
Ctrl
+
Alt
+
Del
to restart
the computer.
e.g. hard disk