63
Fingerprint Reader
You can increase your computer’s security level by setting the BI OS level described in this section.
Performed by the Computer Administrator.
1Register the Supervisor Password.
You have to register the Supervisor Password to proceed to the next step.
If you have already registered the Supervisor Password, you can skip this step, and move on to step 2.
If you have not done this, have enrolled your fingerprint using Protector Suite, and have already made Power-on
Security effective, after step B, your fingerprint authentication will be necessary.
ATurn on or restart the computer.
BPress
F2
or
Del
while [Panasonic] boot screen is displayed soon after the computer starts the startup
procedure.
CSelect the [Security] menu.
DSelect [Setup Supervisor Password], and press
Enter
.
EEnter your password in the [Create New Password], and press
Enter
.
• The password will not be displayed on the screen.
• You can use up to 32 alphanumeric characters (including spaces).
• The case (upper/lower) is ignored.
• Use only the upper horizontal row of numeric keys to input your password.
• You cannot use
Shift
and
Ctrl
to input a password.
FEnter your password again in [Confirm New Password], and press
Enter
.
2Set the High Security Level.
ASelect [Fingerprint Security], and press
Enter
.
BSelect [Security mode], and select [High].
• Default setting: Simple
CPress
Esc
to close the sub-menu.
DPress
F10
, select [Yes], and press
Enter
to exit the Setup Utility.
NOTE
In the [High] security mode, you have to enter the Supervisor or User Password even a fter fingerprint authentication.
In the [Simple] security mode, you do not have to enter the Supervisor or User password after fingerprint authentication.
To use the Power-on Security feature, enable it in [Control Center] (page 62)
.
Change the setting of [Power-on Security] in the Setup Utility only in the specific case such as the Finger print device
cannot be used.
More Advanced Security