Panasonic DMC-LX1GN About the Lens, About Condensation When the lens Is fogged up

Before Use

nCare for the camera

•Do not shake or cause impact to the camera. The camera may not be operated normally or recording of pictures may be disabled, or the lens may be damaged.

•Sand or dust may cause a malfunction of the camera. When you use the camera on a beach etc., take care so that sand or dust does not get into the camera.

•When you use the camera on a rainy day or on a beach, take care so that water does not get into the camera.

•If seawater splashes onto the camera, wet a soft cloth with tap water, wring it well, and use it to wipe the camera body carefully. Then, wipe it again with a dry cloth.

nAbout the LCD monitor

•Do not press the LCD monitor strongly. It may cause uneven colours on the LCD monitor or a malfunction of the LCD monitor.

•In a place with drastic temperature changes, condensation may form on the LCD monitor. Wipe it with a soft, dry cloth.

•If the camera is extremely cold when you turn the camera on, the image on the LCD monitor is slightly darker than usual at first. However, as the internal temperature increases, it goes back to the normal brightness.

Extremely high precision technology is employed to produce the LCD monitor screen. The result is more than 99.99% effective pixels with a mere 0.01% of the pixels inactive or always lit. However, this will not be recorded on the pictures in the card.

nAbout the Lens

•Do not direct the lens to the sun or strong light sources. It may cause not only a malfunction of the camera but irreversible damage to your eye.

•Do not press the lens strongly.

•Leaving the camera with the lens facing the sun may cause a malfunction. Be careful when you put the camera outside or near a window.

nAbout Condensation (When the lens

is fogged up)

Condensation takes place when the ambient temperature or humidity is changed as follows:

Be careful of condensation since it causes stains on the lens, fungus or malfunction.

•When the camera is brought inside from the cold to a warm room.

•When the camera is moved from outside to an air-conditioned car.

•When cool wind from an air conditioner or other is directly blown onto the camera.

•In humid places

Put the camera into plastic bag until the temperature of the camera is close to the ambient temperature to avoid condensation. In case of condensation, turn the camera off and then leave it for about 2 hours.

When the camera becomes close to the ambient temperature, the fog disappears naturally.

3

VQT0S46