Getting started
RQT9334
(ENG)
11
Preparing the Power SupplyThe unit is in the standby condition (the [Í] indicator lights)
when the AC power supply cord is connected. The primary
circuit is always “live” as long as the AC adaptor is connected
to an electrical outlet.
≥When connecting the A C adaptor, use the unit a fter setting it
vertically. Placing the unit with the stand closed
(e.g.:D10, 3 in “Installation of the unit”) may cause d amage
to or malfunction with the AC ada ptor.
To conserve power
This unit consumes 0.5 W (Approximately 5 W when Quick
Start is set to “On”) of power even when turned off. When the
unit is not going to be used for a long time, disconnect the AC
power supply cord from the household AC outlet.
This unit can be used i n places without an AC outlet, such a s
outdoors, by attaching the include d battery pack.
≥The battery is not charged at the time of purchase. Charge
before initial use.
≥The battery is designed only for use with this unit . It cannot be
used with other equipment.
∫Attaching the battery pack
Turn the unit off before attaching or de taching the battery pack.
≥Attach the battery after closing with the LCD screen facing
inwards and the stand open.
∫Detaching the battery pack
When not using for long periods of time
≥Detach the battery pack (Dabove).
(Even when the unit is turned off, there is a small amount of
voltage running through the unit, and this may result in a
malfunction.)
≥Recharge the battery f or re-use.
∫Recharging the battery pack
Attach the battery pack and connect the AC
adaptor (>left).
≥The [CHARGE] indicator lights while charging the battery, and
the [CHARGE] indicator turns off wh en battery charging is
finished.
∫Approximate recharging and play times (Hours)
*1 When the unit is off [at 20
o
C (68
o
F)]
*2 At room temperature using headphones [at 20
o
C (68
o
F)]
≥
The times indicated on the above may di ffer depending on use.
≥To change the LCD brightness (>13, “Adjusting the pictures
on the LCD screen”).
∫Checking the remaining battery charge
When the unit is on (>12, “Turning on/off the unit”) and
powered by the battery pack
Press [SUB MENU] to check on the LCD
(displays for a few seconds).
Using the unit connected to the
AC adaptor
Using the battery pack
AC adaptor
(included)
To a household
AC outlet
AC power supply cord
(included)
1
23
RELEASE
DETACH ATTACH
RELEASE
DETACH ATTACH
Bottom side of this unit
Battery pack
(included)
Clicks into place.
Check to make sure i t is securely fa stened.
2Slide in to the right.
1Bring in from the
left, aligning the
grooves.
Recharging*1
Play*2
LCD brightness level
j5 0 +5
72.5 2.25 2
RELEASE
DETACH ATTACH
Bottom side of this unit
2Slide.
1Press and hold.
[CHARGE] indicator
(Yellow light)
(screen)
(flashing)
Recharge
Appears automatically when there is only
a few minutes of charge remaining.
DMPB15P-RQT9334_eng.book 11 ページ 2009年3月28日 土曜日 午後2時39分