Cannot obtain IP address using DHCP.
Please check the connection or router settings.
¾If you use a hub, then check the connection between the hub and the router.
jUse the UPLINK port of the hub to connect to a router. (> 31)
jCheck whether or not the hub’s Link lamp lights up. If it does not light up, then check the cable connection, LAN terminal connection, cable itself (a crossover cable may have been used by mistake), etc.
¾If the above conditions are OK, then the router may not operate in DHCP mode. Check the router settings and operation. You may reset the router to restore it to normal.
This IP address is already in use.
Please check the IP address setting.
¾This unit’s IP address is used by another device. Check the IP addresses of this unit, personal computers, and routers, etc. If necessary, reconfigure them to avoid IP addresses from being duplicated.
Unable to perform Connection Test.
Please try again.
IP address not set correctly.
¾Turn the unit off. Disconnect the power source (the AC adaptor or battery pack) and reconnect it and try again. If the same symptom persists, then consult your dealer.
Connection Test was unsuccessful. No reply from host.
Please check the connection or router settings.
¾If you use a hub, then check the connection between the hub and the router. (> 31)
jUse the UPLINK port of the hub to connect to a router. jIf the hub’s Link lamp does not light up, then check the
cable connection, LAN terminal connection, cable itself (a crossover cable may have been used by mistake), etc.
¾Check the “IP Address”, “Subnet Mask”, and “Default Gateway” in the “IP Address / DNS Settings”. (> 39)
¾If the MAC address information is required, then press [SETUP] to display the “Network” menu. (> 39)
Cannot connect to network.
Please confirm Network Settings or
Internet Access in Setup.
¾When you set
Reference
VQT2J81
(ENG)
45
