Panasonic DMR-EZ47VEB quick start Viera Link, Dvb-T

General Issues DVB-T (Continued)

Page

Unusual station sorting.	 The station sorting of this unit is pre-defined. Use profiles to sort the	58
	stations as you want them.
The digital channel information	 Select the length of time (3–10 sec.) in the “On-Screen Messages” in the	62
does not appear.	Setup menu.
	 The digital channel information will not appear during playback or	−
	recording.
No Digital TEXT	 When subtitle is on or additional information in the digital channel	−
	informaion is displayed, Digital Text does not work.
After the auto setup, there aren’t	 “Shipping Condition” was performed or the unit was in the delivery status.	−
any stations in the station list	The auto setup was then started and interrupted.
although found stations were	Do an auto setup again and let it continue right through to the end.
displayed during auto setup.	The data is only saved after this has been completed.
The Signal Strength is over 100%	 Reduce the signal amplification at your aerial.	59
(> 10)
Poor picture in spite of good signal	 Overmodulation makes the signal strength display go to red.	−
quality.	Readjust the picture with your room aerial until the picture quality
	improves.

General Issues	VIERA Link		Page
VIERA Link doesn’t work.		 Check the HDMI cable connection. Check that “HDMI” is displayed on the	−
		front display when the power for the main unit is set to On.
		 Make sure that “VIERA Link” is set to “On”.	63
		 Check the “HDAVI Control” settings on the connected device.	−
		 If the connection for the equipment connected with an HDMI cable was	−
		changed, or if there was a power failure or the plug was removed from
		the household mains socket, “HDAVI Control” may not work. In this case,
		perform the following operations.
		1. When the HDMI cable is connected to all equipment with the power on,
		turn the TV (VIERA) on again.
		2. Change the TV (VIERA) settings for the “HDAVI Control” function to
		off, and then set to on again. (For more information, see the VIERA
		operating instructions.)
		3. Switch the VIERA input to HDMI connection with this unit, and after this
		unit’s screen is displayed, check that “HDAVI Control” is working.
The control panel does not appear.		 The control panel is only displayed when connected to a TV with “HDAVI	43
		Control 2” function.

Reference

79

RQT8857