FP | 9.1 |
|
|
The
To disconnect later, click on this icon and select 'Disconnect'.
3.Use a standard Internet browser that is set up as described under Internet Browser to Test the FP
4.In the location field the IP address of the
The page "MAIN.HTM" as set up with the configurator should be displayed.
Windows 2000 and Windows XP setup for IP communication via RS232C null modem cable:
Create a new “direct connection”:
1.Start → Settings → Network and
Connection
2.Click [Next] and select “Connect directly to another computer”. Click [Next].
3.Select “Guest” to define the
4.At “Select a device:” locate the “Communication cable between two computers (COMx)”. Click [Next].
Comment:
COMx, i.e. the computer's RS232C COM port, should be used for the null modem cable. Perhaps the proper COM port number will not be found because it is already used by an installed modem driver. If necessary, remove the common modem driver (see “Control Panel / Telephone and Modem”).
5.Select “For all users”. Click [Next].
6.Enter a name for this connection. For example “Null modem with COM1 and 19200bps to
The
If the
1.Enter the name and password as defined in the FP
The
To disconnect later, click on this icon and select 'Disconnect'.
2.Use a standard Internet browser that is set up as described under Internet Browser to Test the FP
3.In the location field the IP address of the
125