
Quick Guide
∫Charging the battery
| Charging lamp | |
| [CHARGE] A | |
Lights up: | ||
| ||
Charging | ||
| ||
| Goes off: | |
| Charging completed |
1Connect the AC cable to the AC adaptor
and the AC outlet.
2Insert the battery into the AC adaptor by aligning the arrows.
∫Inserting the battery
Install the battery by inserting it in the direction shown in the figure.
AInsert the battery until it clicks and locks.
∫Inserting/removing an SD card
Access lamp [ACCESS] A
≥When this unit is accessing the SD card, the access lamp lights up.
1)Open the LCD monitor.
≥Check that the access lamp has gone off.
2)Open the SD card/terminal cover and insert (remove) the SD card into (from) the card slot.
≥Face the label side B in the direction shown in the illustration and press it straight in as far as it will go.
≥Press the center of the SD card and then pull it straight out.
3)Securely close the SD card/terminal cover.
≥Securely close it until it clicks.
∫Turning the unit on/off
Turning the unit on and off with the power button
Press the power button to turn on the unit.
AThe status indicator lights on.
≥To turn off the unit, hold down the power button until the status indicator goes off.
Turning the unit on and off with the LCD monitor/viewfinder
Opening the LCD monitor or extending the viewfinder turns on the unit. Closing the LCD monitor/viewfinder turns off the unit.
To turn on the unit
AThe status indicator lights on.
12
VQT3B18