Operating Instructions
2.3How to turn on Network Camera for Installation
Connect the DC plug of the AC adaptor to the DC IN jack and a category 5 straight/ cross cable to the Ethernet port. Connect the AC plug of the AC adaptor to the power outlet to turn on Network Camera. Ethernet Indicator turns on when the network is active.
| AC adaptor |
Power |
|
Outlet | DC plug |
Connect a category 5 cable to the Ethernet port.
Notes
Thread the AC adaptor line through the hook downward.
•AC adaptor is used as the main disconnect device, so ensure that the power outlet is located/installed near the equipment and is easily accessible.
•Use only the specified Panasonic AC adaptor PQLV10 (Order No. PQLV10Y).
•When you set up Network Camera in [Type 3], connect it temporarily in [Type 1], [Type 2] or [Type 4].
•When the Ethernet Indicator is off, confirm that the Ethernet cable is properly connected, or PC, Ethernet hub or broadband router is properly working.
•Thread the AC adaptor line through the hook upward if it is convenient.
20
