performing this procedure, and then
change it back when finished.
3MbN: Select your wireless router’s SSID.
a MSelectN
4Confirm the SSID and then press MOKN.
5Enter the password required to access
the wireless network. a MOKN
RAfter the base unit connects to the
wireless router, Connected to and
your wireless router’s SSID is
displayed.
6MOFFN
Simplified configuration (WPS,
DHCP)
This procedure requires a wireless router that
supports WPS. If your wireless router supports
WPS, make sure the feature is turned on, and
locate its WPS button before beginning this
procedure. The WPS button is typically
labeled “WPS” or has two curved arrows on it.
1MMenuN (right soft key) #523
2MbN: WPS (Easy setting) a
MSelectN
3Press the WPS button on your wireless
router and then press MOKN on the
handset.
RThe base unit searches for your
wireless router and Searching...
is displayed.
RAfter the wireless router is found, the
base unit’s Wi-Fi settings will be
completed automatically. When the
setup is complete, Connected to
and your wireless router’s SSID is
displayed.
4MOFFN
Advanced configuration (static IP
settings)
After using the procedure explained in “Typical
configuration (DHCP)”, page 42 or “Simplified
configuration (WPS, DHCP)”, page 43, use
the procedure below to set the base unit’s IP
settings manually if necessary.
This procedure is not necessary for most
users.
1MMenuN (right soft key) #500
2MbN: Manual (Static) a MSelectN
3MbN: Select the desired item. a MSelectN
4Enter the desired setting. a MOKN
RPress MFEN to move the cursor if
necessary.
5Set the other items as necessary.
6MbN: <Save> a MSelectN a MOFFN
Smartphone Connect app
Once you have configured the base unit’s
Wi-Fi and network settings, you are ready to
download the Smartphone Connect app.
Download information is available at the web
page listed below.
www.panasonic.net/pcc/support/tel/air
For information about using the app, refer to
the Smartphone Connect App Guide, which is
available for download at the web page listed
above.
Other network features
Wi-Fi repeater mode
You can increase the signal range of your
wireless network by turning on the base unit’s
Wi-Fi repeater mode feature.
1MMenuN (right soft key) #538
2MbN: Select the desired setting. a MSaveN
Important:
RIf using Wi-Fi repeater mode, do not place
the base unit and your wireless router too
close to each other. If they are too close,
For assistance, please visit http://www.panasonic.com/help 43
Smartphone Integration
PRW120(en)_1016_ver041.pdf 43 2013/10/16 10:40:19