Panasonic KX-TG2680N operating instructions Pager Mode Setting, To select Received call, press

Pager Call

Pager Mode Setting

After subscribing to a Caller ID service (p. 34), you can select one of the following pager mode settings. The unit will alert your pager:

Recorded MSG: After the unit records an incoming message (factory preset),

OR

Received call: Each time the unit receives a Caller ID call, even if the caller does not leave a message.

If you want to change the mode, proceed as follows.

1	Press (FUNCTION/CH).
2	Press Ö or Ñ repeatedly until the arrow
	points to “Program”.
3	Press á (Yes key).
4	Press Ö or Ñ repeatedly until the arrow
	points to “TAD program”.
5	Press á (Yes key).
	•The base unit display shows programming
	options.
6	Press (6).
	•The current setting is displayed on the base
	unit.
7	To select “Received call”, press (2).
	OR
	To select “Recorded MSG”, press (1).
8	Press á (Save key).
	•A beep sounds.

•To return to the standby mode, press (OFF).

HProgram

Calling pager

GF H=Yes

HSave DIRECT#

Set flash time

GF H=Yes

Set dial mode HTAD program

GF H=Yes

Answering system setting. See base unit.

Base unit display

Pager mode :Recorded MSG

Base unit display

Pager mode :Received call

•If you select “Received call” and set the unit to call your pager (p. 65), the unit will alert your pager even if the answering system is not turned on.

•If you select “Received call”, and a Call ID call is received with no telephone number, the unit will only alert your pager if the caller leaves a message.

66