Panasonic KX-TG6821SA, KX-TG6812SA Advanced new message alerting features, Audible message alert

Answering System

Advanced new message alerting features

Audible message alert

This feature allows the base unit to beep to inform you of a new message arrival when new messages are recorded. The base unit beeps 2 times every minute until you listen to the messages, if the “Base Unit Beep” setting is turned on. The default setting is “Off”.

1MN#339

2MbN: Select the desired setting. a MOKN a MeN

New message alert by a call

This feature allows the unit to make a call to the pre-stored phone number and inform you that a new message has been received by announcement.

To use this feature, you must:

–store a phone number to which the unit makes the call to.

–turn on the new message alert setting. After you answer the new message alert call, you can listen to messages from that call (page 36).

Important:

RA new message alert is stopped 1 minute after the unit starts to call. The unit will not retry the call even if the call is not answered.

Storing a phone number to which the unit makes an alert call

nFrom the phonebook:

1 MN#338

2 MbN: “Notification to” a MOKN

a MN

3 MbN: “Phonebook” a MOKN

4 MbN: Select the desired phonebook entry. a MOKN a MeN

nBy entering a phone number:

1 MN#338

2 MbN: “Notification to” a MOKN

a MN

3 MbN: “Manual” a MOKN

4 Enter the desired name (16 characters max.; page 41). a MOKN

5 Enter the desired number (24 digits max.). a MOKN 2 times a MeN

Turning on/off the new message alert setting

1MN#338

2MbN: “On/Off” a MOKN

3MbN: Select the desired setting. a MOKN a MeN

Editing the set phone number

1MN#338

2MbN: “Notification to” a MOKN

3 MN a MbN: “Edit” a MOKN

4Edit the name if necessary (16 characters max.; page 41). a MOKN

5Edit the phone number if necessary (24 digits max.). a MOKN 2 times a MeN

Erasing the set phone number

1MN#338

2MbN: “Notification to” a MOKN

3 MN a MbN: “Erase” a MOKN

4MbN: “Yes” a MOKN a MeN

R The new message alert setting is turned off.

Activating/inactivating the remote access code to play messages

If you activate this feature, you must enter the remote access code (page 36) to play the new message from the new message alert call. This is so that unauthorised parties cannot listen to your messages. The default setting is “Inactivate”.

35

TG68xxSA(en)_0619_ver011.pdf 35

2013/06/19 17:43:17