2.14 Initializing the VPS During Installation

2.14 Initializing the VPS During Installation

Before programming the VPS for the first time, perform the initialization procedure described below. All settings are reset to their default values. Recorded messages are erased. System prompts (including customized prompts) are preserved.

1.Turn the power switch to the off position.

2.Set the Mode Switch to position 5 (see 2.3 Names and Locations).

1 2 3 4

0

1

3.Turn the power switch to the on position.

4.Confirm that the RUN indicator blinks 5 times.

This may take several minutes. The ALARM indicator and RUN indicator will first blink intermittently before the RUN indicator blinks 5 times.

5.Turn the power switch off at the VPS.

6.Set the Mode Switch to position 0.

1 2 3 4

0

1

7.Turn the power switch back on at the VPS.

After initializing the VPS, continue with the installation procedure and/or begin programming the VPS.

74

Installation Manual

Document Version 3.0 2010/06

Page 74
Image 74
Panasonic KX-TVA50 installation manual Initializing the VPS During Installation