Panasonic PT-D6000, PT-D5000 Digital Cinema Reality, Input Resolution, Blanking, Clamp Position

ADVANCED MENU

Remote control

See “Navigating through the menu” on page 15.

See “Main menu and Sub-menu” on page 12.

DIGITAL CINEMA REALITY

You can improve the vertical resolution for PAL (or SECAM) 576i, NTSC 480i, 1080/50i or 1080/60i signals. Press I H to cycle through the options.

Setting range

Models	Vertical	Horizontal
PT-DZ6710/PT-DZ6700	0 - 599	0 - 959
PT-DW6300	0 - 399	0 - 639
PT-D6000/PT-D5000	0 - 383	0 - 511

INPUT RESOLUTION

Input resolution adjustment achieves the best image when the screen flickers or halo is observed around the contour, vertical stripes or stuck pixels appear on the screen. Press F G to select the required option to change, and I H to change the value. The initially displayed values vary according to the selected input signal.

Settings

	Detects PAL (or SECAM) 576i, 1080/50i, NTSC
AUTO	480i and 1080/60i input signals and change the
	setting properly.
OFF	Deactive
	Detects only PAL (or SECAM) 576i and 1080/50i
25p FIXED	signals, and adjust the vertical resolution of the
	image to 2:2 pulldown.
	Detects only NTSC 480i and 1080/60i signals,
30p FIXED	and adjust the vertical resolution of the image to
	2:3 pulldown.

NOTE:

•25p FIXED or 30p FIXED setting with signals that is not 2:2 pulldown may result low quality.

TOTAL DOTS

DISPLAY DOTS

TOTAL LINES

DISPLAY LINES

NOTE:

•The vertical stripes will not appear on the all white signal image.

•The picture may be distorted during the adjusting operation, but this is not a fault.

•The input resolution can be adjusted only when RGB signal input is applied with RGB1 and RGB2 IN.

•With PT-DW6300/PT-D6000/PT-D5000, automatic adjustment is not available if signals having a dot clock frequency of more than 150 MHz are supplied.

BLANKING

You can perform fine adjustments for blanking if noise appears at the ends of the screen or the image protrudes out of the screen during image projection using a VCR and so on. Press F G to select the edge to adjust, and I H to move the inner edge of the blank.

UPPER	LOWER
LEFT	RIGHT

CLAMP POSITION

When black part of the image is losing its colour or becomes green, you can adjust to the best colour. Press I H to change the value.

Setting range: 0 to 255

NOTE:

• Available with signals from RGB 1 IN/RGB 2 IN only.

I: Moves the inner edge of the blank area to outside.

H: Moves the inner edge of the blank area to inside.

ENGLISH - 22