Panasonic PT-DZ6700, PT-D5000 Remote 2 in terminal, Pin assignments and control, Other, Contact

Technical Information

REMOTE 2 IN terminal

Using the REMOTE 2 IN terminal provided on the connection terminals of the main unit, it is possible to operate the projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be received.

Remote External

control control

Remote control/External control

Standby ON

LAMP

Projector set up in a meeting room Control panel located in a different room

Pin assignments and control

Pin No.	Signal name	Open (H)	Short (L)
1	GND		GND
2	POWER	OFF	ON
3	RGB1	Other	RGB1
4	RGB2	Other	RGB2
5	VIDEO	Other	VIDEO
6	S-VIDEO	Other	S-VIDEO
7	DVI-D	Other	DVI-D
8	SHUTTER	OFF	ON
9	RST / SET	Controlled by remote	Controlled by external
		control	contact

NOTE:

•The following buttons on the remote control and the operation area of the projector can no longer be operated when pins 1 and 9 are shortened: POWER button and SHUTTER button. Neither will it be possible to use the RS-232C commands or network functions corresponding to these functions.

•If you short pin 1 and pin 9, and also short one of the pins from 3 to 7 and pin 1, then the following buttons on the projector operating area and the remote control can no longer be operated: POWER, RGB1, RGB2, DVI-D, VIDEO, S-VIDEO, SDI and SHUTTER buttons. Neither will it be possible to use the RS-232C commands or network functions corresponding to these functions.

Appendix

ENGLISH - 47