Using WebBrowser (cont.)
Monitor information window
This page indicates the projector status.
To access this page from other pages, click [Status] at the left of the window.
Monitored information |
| Network information |
On this window, click the [Status information] tab. |
| On this window, click the [Network status] tab. |
The monitor information is refreshed at fixed intervals, but the current exact information can be checked by clicking [View] [Reload Page].
If [SELF TEST Error(Detail)] appears on the monitored information window, click it to view the error details.
If [FAILED] appears
Item | Description |
MAIN CPU BUS | There is a problem with a microcontroller circuit. Contact your dealer. |
FAN | There is a problem with the fan or fan drive circuit. Contact your dealer. |
INPUT/OUTPUT AIR TEMP. | Excessive temperature by the air intake or around the lamp area. |
| The following may be causing the problem. |
| • The ambient temperature is too hot; the projector may be near a heater |
| • The exhaust vent is obstructed |
LAMP REMAIN TIME | The lamp has been used for longer than its rated useful life, and it is time to replace it. |
LAMP STATUS | The lamp could not be lit. |
| Allow the bulb of the light source to cool, and then turn on the projector. |
ARF UNIT | ARF UNIT is not installed or remaining filter level is low. |
| See instruction manual of the projector for detail. |
INPUT AIR TEMP.SENSOR | There is a problem with the air intake temperature sensor. Contact your dealer. |
OUTPUT AIR TEMP.SENSOR | There is a problem with the exhaust temperature sensor. Contact your dealer. |
BATTERY | The battery must be replaced. Contact your dealer. |
37
