When controlling multiple projectors individually or simultaneously with a single remote control unit, a projector ID number must be set into the remote control unit as described in the following steps.
RGBVIDEO
A
ALLSET
#When setting the projector ID number, move the mode switch to the left side (Numeric).
$Press the ID SET button on the remote control unit.
The projector ID number which is currently set will be displayed on the screen.
%Press the numeric (0 - 9) buttons on the remote control unit to set the ID number. The entered ID number will be displayed on the screen. (You can set from the number 1 to the number 64.)
BIf the entered ID number is 10 - 64, the ID number setting will be completed.
BIf the ID number entered is less than 10, press any button other than the numeric buttons or the ID SET/ALL button, or wait for about 5 seconds to complete the setting.
Getting started
NOTE:
BIf the entered ID number is more than 64, the ID number will return to the one set before the ID SET button was pressed.
BThe ID number setting screen will be canceled if no number is entered for 5 seconds or if any button except the numeric buttons is pressed.
BIf the ID SET button is pressed after a number less than 10 is entered, the entered number will be cancelled.
BIf ID number is set to “ALL” by pressing the ID ALL button, the projectors can be controlled regardless of their ID number setting.
BThe projector cannot be turned on and off from the remote control unit if the “CONTROLLER ID” does not match the projector ID number. For more details on projector ID number setting, see page 49.
BThe projector ID number in the remote control unit is set to “ALL” by default. It is therefore not necessary to set a projector ID number when only one projector is used.
E NGLISH |