Panasonic PT-L785U Control commands, Cable specifications, PON, POF, AVL, IIS, Q$S, OSH, Volume, Control, Remarks, DVI=DVI, Lamp ON, Contents, Power ON, RG1=RGB1, RG2=RGB2

Control commands

The commands which the personal computer can use to control the projector are shown in the following table.

Command		Control		Remarks
		Contents
			In standby mode, all commands other than
PON		Power ON	the PON command are ignored.
			BThe PON command is ignored during
			lamp ON control.
			BIf a PON command is received while the cooling
POF		Power OFF	fan is operating after the lamp has switched off,
			the lamp is not turned back on again straight
			away, in order to protect the lamp.
AVL		Volume	Parameter
			000-063 (Adjustment value 0-63)
			Parameter
IIS		Input signal	VID=VIDEO	SVD=S-VIDEO
		selection	RG1=RGB1	RG2=RGB2
			RG3=RGB3	DVI=DVI
			Callback
		Lamp ON	0 = Standby
Q$S			1 = Lamp ON control active
		condition query
			2 = Lamp ON
			3 = Lamp OFF control active
			Operation will be switched between ON and
OSH	Shutter function		OFF each time the command is sent. Do
			not switch operation ON and OFF after only
			short periods of time.

Cable specifications(When connected to a personal computer)

At the projector			At the computer
			(DTE specifications)
	1	NC	NC	1
	2			2
	3			3	Others
	4	NC	NC	4
	5			5
	6	NC	NC	6
	7			7
	8			8
	9	NC	NC	9

E NGLISH -73